3/4" Plastic Water Butt Tap
Prices include VAT
Below are the available bulk discount rates for each individual item when you purchase a certain amount
- Buy 2 or above and get 5% off
Water Butt Replacement Tap
This plastic tap fits 3/4" BSP threaded holes present in almost all water butts.
The anti-glug design of the tap and 3/4 inch connection means that water flows at a higher rate than most other water butt taps.
When fitting the tap make sure the washer is on the inside of the water butt and tighten the tap from the inside using the plastic backnut.
We recommend wrapping some PTFE tape around the thread before fitting just incase the thread on your water butt connection is a bit worn. This will help ensure a good seal and prevent dripping.
- Simple to fit and secured in place with nut inside the water butt
- Fits 3/4" BSP threaded holes present in almost all water butts
- Suitable for all above ground tanks and water butts
- Material: Polypropylene
- Colour: White
- 3/4" Hi-flow, Anti-glug Plastic Tap
- Rubber Washer
Posted by Unknown on 14th May 2020
I recently bought two 100 litre water butts and linked the outlets together and used one of the taps supplied.
Even when butts were full the flow was not good,saw the Cetic full flow tap on line so ordered it.
Very prompt delivery and tap is now fitted and works very well.
Posted by Richard Parry on 21st Aug 2019
WE needed a bigger tap, as the half inch was to slow, these fit the bill exactly.